Cisco ISE - Line Card ISE Configuration Manual page 58

How to Configure AToM VCs on the 4-Port ATM ISE Line Card
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
policy-map policy-map-name
Example:
Router(config)# policy-map out_vbr-nrt
Step 4
class class-default
Example:
Router(config-pmap)# class class-default
Step 5
queue-limit number-of-cells cells
Example:
Router(config-pmap-c)# queue-limit 400 cells
Step 6
exit
Example:
Router(config-pmap-c)# exit
Step 7
exit
Example:
Router(config-pmap)# exit
Cisco IOS Release 12.0(27)S
58
class class-default
queue-limit number-of-cells cells
exit
exit
interface atmslot/port
atm clock internal
atm pvp vpi l2transport
cell-packing cells mcpt-timer timer
vbr-nrt pcr scr mbs
service-policy output policy-map-name
xconnect peer-router-id vcid encapsulation mpls
Software Configuration of ATM ISE Line Cards for Cisco 12000 Series Routers
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode.
Specifies the name of the service policy to configure with
the shaping queue size.
Specifies to configure the default class.
Specifies or modifies the maximum number of cells the
queue can hold for a class policy configured in a policy
map.
Exits class mode.
Exits policy-map mode.