Cisco ISE - Line Card ISE Configuration Manual page 71

Software Configuration of ATM ISE Line Cards for Cisco 12000 Series Routers
Command or Action
Step 8
police rate scr cps atm-mbs mbs cells
conform-action transmit exceed-action drop
Example:
Router(config-pmap-c)# police rate 100000 cps
atm-mbs 1024 cells conform-action transmit
exceed-action drop
Step 9
exit
Example:
Router(config-pmap-c)# exit
Step 10
exit
Example:
Router(config-pmap)# exit
Step 11
policy-map vbr3
Example:
Router(config)# policy-map vbr3
Step 12
class class-default
Example:
Router(config-pmap)# class class-default
Step 13
set mpls experimental mpls-exp-value
Example:
Router(config-pmap-c)# set mpls experimental 4
Step 14
police rate pcr cps delay-tolerance cdvt
conform-action transmit exceed-action drop
Example:
Router(config-pmap-c)# police rate 250000 cps
delay-tolerance 10 conform-action transmit
exceed-action drop
Step 15
service-policy child-vbr3
Example:
Router(config-pmap-c)# service-policy
child-vbr3
After you configure the policy map, you must explicitly attach it to a PVC using the service-policy
command as described in the
How to Configure AToM VCs on the 4-Port ATM ISE Line Card
Purpose
Specifies a maximum bandwidth usage by a traffic class
through the use of a token bucket algorithm. For a
description of the conform-action and exceed-action
keywords, see
Exits class mode.
Exits policy map mode.
Specifies the name of the parent service policy to configure.
Specifies to configure the default class.
(Optional) Specifies the value used to set the MPLS EXP
bits defined by the policy map. Valid values are numbers
from 0 to 7.
Specifies a maximum bandwidth usage by a traffic class
through the use of a token bucket algorithm. For a
description of the conform-action and exceed-action
keywords, see
Attaches the child service policy to the VBR1 policy map.
"Attaching a Service Policy to a PVC" section on page
Table 5 on page 16.
Table 5 on page 16.
Cisco IOS Release 12.0(27)S
72.
71