Cisco ISE - Line Card ISE Configuration Manual page 48

How to Configure AToM VCs on the 4-Port ATM ISE Line Card
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
interface atmslot/port
Example:
Router(config)# interface atm1/0
Step 4
pvc [name] vpi/vci l2transport
Example:
Router(config-if)# pvc 10/50 l2transport
Step 5
encapsulation aal5
Step 6
oam emulation-enable
Step 7
oam-pvc manage [frequency]
Example:
Router(config-if-l2trans-pvc)# oam-pvc manage 0
Step 8
xconnect peer-router-id vcid encapsulation mpls
Example:
Router(config-atm-l2trans-pvc)# xconnect
13.13.13.13 100 encapsulation mpls
Cisco IOS Release 12.0(27)S
48
enable
configure terminal
interface atmslot/port
pvc vpi/vci l2transport
encapsulation aal5
oam emulation-enable
oam-pvc manage [frequency]
xconnect peer-router-id vcid encapsulation mpls
Software Configuration of ATM ISE Line Cards for Cisco 12000 Series Routers
Purpose
Enables privileged EXEC mode.
Enter your password if prompted.
•
Enters global configuration mode.
Specifies an ATM interface to configure.
Specifies a PVC with the specified VPI and virtual circuit
identifier (VCI) to configure.
Sets encapsulation to be AAL5.
Enables OAM emulation.
Enables end-to-end F5 OAM loopback cell generation and
OAM management for an ATM PVC or VC. Frequency is
the time delay (0 to 600 seconds) between transmitting
OAM loopback cells.
Binds the attachment circuit to a pseudowire VC.