Cisco ISE - Line Card ISE Configuration Manual page 42

How to Configure AToM VCs on the 4-Port ATM ISE Line Card
Command or Action
Step 3
interface atmslot/port
Example:
Router(config)# interface atm1/0
Step 4
xconnect peer-router-id vcid encapsulation mpls
Router(config-if)# xconnect 10.0.0.1 123
encapsulation mpls
Example
Router> enable
Router# configure terminal
Router(config)# interface atm1/0
Router(config-if)# xconnect 10.0.0.1 123 encapsulation mpls
Configuring ATM Cell Packing over MPLS on PVCs
Perform this task to configure ATM cell packing on permanent virtual circuits (PVCs).
Restrictions
•
•
•
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
Cisco IOS Release 12.0(27)S
42
The cell packing function can only be configured when the ATM VC is configured for AAL0
encapsulation. It has no meaning if the VC is configured with AAL5 encapsulation.
In cell packing, only cells from the same VC/VP can be packed into one MPLS packet. Cells from
different connections cannot be concatenated into the same MPLS packet.
The number of cells that can be packed varies from 2 to 28.
enable
configure terminal
interface atmslot/port
atm mcpt-timers [timer1-timeout timer2-timeout timer3-timeout]
pvc vpi/vci l2transport
encapsulation aal0
cell-packing cells mcpt-timer timer
xconnect peer-router-id vcid encapsulation mpls
Software Configuration of ATM ISE Line Cards for Cisco 12000 Series Routers
Purpose
Specifies an ATM interface.
Binds the attachment circuit to the interface.