Oki CX1145 MFP Admin Manual page 308

Error Code
Logon to file server failed. Check user-
name and password.
2D64
There are too many documents in the
2D65
folder. Failed in creating new document.
Failed to process your job. Insufficient
2D66
storage space.
FTP service is not available
2D67
File Sharing service is not available
2D68
2DC0 Job canceled
Power failure occurred
2DC1
Store to e-Filing
2A20 Failed to acquire resource.
System fatal error.
2A40
2A50 Job canceled.
Power failure occurred.
2A51
2B10 There was no applicable job.
2B11 Job status failed.
2B20 Failed to access file.
Message size exceeded limit or maximum
2B21
size.
Insufficient disk space.
2B30
Failed to access Electronic Filing.
2B31
Failed to print Electronic Filing document.
2B32
Message Corrective Action
Make sure you specify correct user name
and password to logon the file server, or
you specify correct file server. Then retry
the scan.
Delete the data in the local storage folder
in the equipment and retry the scan.
Delete the data in the destination folder in
the equipment and retry the scan.
Ask your administrator whether the FTP
service is configured correctly.
Ask your administrator whether the SMB
protocol is enabled.
(Job was canceled.)
Make sure that the power cable is con-
nected properly and it is inserted securely.
Resend the job.
Retry the scan.
Turn the power OFF and then back ON.
Retry the scan.
(Job was canceled.)
Make sure that the power cable is con-
nected properly and it is inserted securely.
Resend the job.
Retry the scan.
Retry the scan.
Retry the scan.
You are sending too many documents at a
time. Send your documents separately.
Delete unnecessary documents in e-Filing
and try again.
Make sure that the specified e-Filing or
folder exists. (If not, this error would not
occur.) Delete the specified e-Filing or
folder and reset them. Retry the job in
error. If the specified e-Filing or folder can-
not be deleted, contact your service repre-
sentative.
Make sure that the specified document
exists. (If not, this error would not occur.)
Delete the specified document and reset
them. Retry the job in error. If the speci-
fied document cannot be deleted, contact
your service representative.
TopAccess Error Messages 307