Oki CX1145 MFP Admin Manual page 126

6) Use Stateful Address
Use the IPv6 addresses issued from DHCPv6 server.
- Use DHCPv6 Server for IP Address — Select whether or not the IPv6 address which is
issued from the DHCPv6 server is used for this equipment.
- Use DHCPv6 Server for Options — Select whether or not the optional information (IPv6
address for the DNS server, etc.) except the IPv6 address for this equipment, which is
issued from the DHCPv6 server is used on this equipment.
When the DHCP server does not have a primary and secondary DNS server addresses, the
blank data is set to in the primary and secondary DNS server addresses even if you set the
correct primary and secondary DNS server addresses manually in the DNS Session. In that
case, select "Disable" here and set the correct primary and secondary DNS server address
in the DNS Session.
P.128 "Setting up the DNS Session"
- IP Address — IPv6 addresses obtained from DHCPv6 Server is displayed.
One IPv6 address can be obtained from the DHCPv6 server.
When the "Use Stateful Address" option is selected, you can select neither "Manual" nor
"Use Stateless Address".
Setting up the IPX/SPX
You can set the IPX/SPX protocol to enable the communication over IPX/SPX. The IPX/SPX
must be configured to enable Novell printing with NetWare server 5.1, 6.0, 6.5 over IPX/SPX.
1
2
3
1) Enable IPX/SPX
Select whether the IPX/SPX protocol is enabled or disabled. Please enable this when con-
figuring Novell printing over the IPX/SPX network.
2) Frame Type
Select the desired frame type for IPX/SPX.
- Auto Sense — Select this to use an appropriate frame type that the equipment found
first.
- IEEE 802.3/Ethernet II/IEEE 802.3 Snap/IEEE802.2 — Instead of "Auto Sense", select
the frame types to be used from these options.
3) Actual Frame
This displays the actual frame type of the equipment.
Setting up from TopAccess 125