Oki CX1145 MFP Admin Manual page 123

7 TopAccess Administrator Mode
When the DHCP server does not have a SMTP server address, the blank data is set to in the
SMTP server address even if you set the correct SMTP server address manually in the
SMTP Client. In that case, select "Disable" here and set the correct SMTP server address in
the SMTP Client.
P.136 "Setting up the SMTP Client"
7) Obtain a POP3 Server Address automatically
Select "Enable" when you want to obtain a POP3 server address automatically using the
DHCP server. This setting will apply only when "No AutoIP" or "Dynamic" is selected in the
Address Mode option.
When the DHCP server does not have a POP3 server address, the blank data is set to in the
POP3 server address even if you set the correct POP3 server address manually in the POP3
Network Service. In that case, select "Disable" here and set the correct POP3 server
address in the POP3 Network Service.
P.139 "Setting up the POP3 Network Service"
8) Obtain a SNTP Server Address automatically
Select "Enable" when you want to obtain a SNTP server address automatically using the
DHCP server. This setting will apply only when "No AutoIP" or "Dynamic" is selected in the
Address Mode option.
When the DHCP server does not have a SNTP server address, the blank data is set to in the
SNTP server address even if you set the correct SNTP server address manually in the SNTP
Network Service. In that case, select "Disable" here and set the correct SNTP server
address in the SNTP Network Service.
P.143 "Setting up the SNMP Network Service"
9) IP Address
Enter the static IP address that is assigned to this equipment when "Static IP" is selected in
the "Address Mode" drop down box.
10) Subnet mask
Enter the subnet mask if required when "Static IP" is selected in the "Address Mode" drop
down box.
11) Default Gateway
Enter the gateway address if required when "Static IP" is selected in the "Address Mode"
drop down box.
12) IP Filtering
When you want to set the IP filtering for Raw TCP, LPR, and IPP printing, specify the range
of IP addresses in the Start Address and End Address fields.
When you specify the range of IP addresses, only the client that the specified IP address
range is assigned can perform Raw TCP, LPR, and IPP printing.
IP Filtering can restrict the accesses for Raw TCP, LPR, and IPP printing. The accesses
using other protocols are not restricted.
122 Setting up from TopAccess