Oki CX1145 MFP Admin Manual page 121

7 TopAccess Administrator Mode
Setting up the TCP/IP (IPv4)
You can set the TCP/IP protocol to enable communication over TCP/IP. The TCP/IP must be
configured to enable TopAccess, SMB printing, Raw TCP or LPR printing, IPP printing, Save as
file to network folder, Scan to Email, and Internet Fax.
1
2
3
4
5
6
7
8
9
10
11
12
1) Ethernet Speed Duplex Mode
Select the ethernet speed.
When you select a specific ethernet speed, you must select the same ethernet speed as set
in the connected network. If you do not know the ethernet speed that must be used, select
"AUTO".
2) Address Mode
Select how to set the IP address.
- Static IP — Select this to assign the static IP address manually. When this is selected,
enter the static IP address in the IP Address field.
- Dynamic — Select this to assign the IP address using the DHCP with Auto-IP address-
ing enabled. When this is selected, the IP address, subnet mask, default gateway, pri-
mary WINS server address, secondary WINS server address, POP3 server address, and
SMTP server address can be automatically obtained from the DHCP server if the net-
work supports the DHCP, and the IP address can be also assigned using Auto-IP
addressing even if the network does not support the DHCP.
120 Setting up from TopAccess