Transmission/Reception Journal Status Messages - Oki CX1145 MFP Admin Manual

Transmission/Reception Journal Status Messages

The result of the transmission and reception is indicated as follows in the Transmission Journal
and Reception Journal pages in the Logs tab.
The following table describes the Error Code.
Error Code
0011
0012
0013
0020
0030
0033
0042
0050
0053
00B0-00B5
00C0-00C4
00D0-00D2
00E8
00F0
00F1
1C10
1C11
1C12
1C13
Cause
Paper jam
Original jam
Door open
Power interruption
Reset
Polling Error
Memory full
Line busy
Security Mismatch in Relay or Mail Box
transmission
Signal Error or Line Condition Error
HDD error
Software failure
Hardware noise
System access abnormality
Insufficient memory
Message reception error
Message transmission error
Corrective Action
Clear the jammed printing paper.
Clear the jammed original.
Firmly close the open door.
Check the power interruption report.
(The transmission was canceled by press-
ing the [FUNCTION CLEAR] button.)
Check polling options setup (Security
Code, etc.), and check if the polling docu-
ment exists.
Make sure that there is sufficient memory
before making the call again.
Retry communications.
Confirm the remote party's Security Code,
system password and your setup.
Retry communications. Frequent failures
may indicate a phone line problem. If pos-
sible, move the unit to another line and try
your communications again.
Retry communications. If the error still
occurs, contact your service representa-
tive.
Retry communications. If the error still
occurs, contact your service representa-
tive.
Retry communications. If the error still
occurs, contact your service representa-
tive.
Turn the power OFF and then back ON.
Perform the job in error again. If the error
still occurs, contact your service represen-
tative.
When there are running jobs, perform the
job in error again after the completion of
the running jobs. If the error still occurs,
turn the power OFF and then back ON,
and perform the job again.
Turn the power OFF and then back ON.
Perform the job in error again.
Turn the power OFF and then back ON.
Perform the job in error again.
TopAccess Error Messages 299