Configuring Zone-Based Traffic Priority Using Fabric Manager - Cisco MDS 9000 Series Configuration Manual

Configuring Zone-Based Traffic Priority Using Fabric Manager

switch(config)#
Returns to configuration mode.
Step 6 switch(config)# zoneset name QosZoneset vsan 2
Example:
switch(config-zoneset)#
Configures a zoneset called QosZoneset for the specified VSAN (vsan 2) and enters zoneset configuration submode.
To activate a zoneset, you must first create the zone and a zoneset.
Tip
Step 7 switch(config-zoneset)# member QosZone
Adds QosZone as a member of the specified zoneset (QosZoneset).
If the specified zone name was not previously configured, this command will return the Zone not present error
Tip
message.
Step 8
switch(config-zoneset)# exit
Example:
switch(config)#
Returns to configuration mode.
Step 9
switch(config)# zoneset activate name QosZoneset vsan 2
Activates the specified zoneset.
Configuring Zone-Based Traffic Priority Using Fabric Manager
To configure the zone priority using Fabric Manager, follow these steps:
Step 1
Expand a VSAN and then select a zone set in the Logical Domains pane.
Step 2 Click the Policies tab in the Information pane.
You see the Zone policy information in the Information pane (see
on page 91).
Cisco MDS 9000 Series Fabric Configuration Guide, Release 8.x
90
Configuring and Managing Zones
Figure 38: Zone Policies Tab in the Information Pane,