Verifying Campus Fabric Interconnect-Mpls L3Vpn; Verifying Mpls Ldp Configuration; Verifying Mpls Ldp Neighbor Configuration - Cisco Nexus 7000 Series Configuration Manual

Verifying Campus Fabric Interconnect—MPLS L3VPN
• BGP neighbor/peer VPNv4 and IPv4 address family configurations are enabled.
• The redistribute lisp route-map command redistributes the LISP map-cache routes into MP-BGP.
• Aggregate routes within the vrf6000 VRF are enabled to be distributed to the BGP neighbor.
The configurations are relevant to PxTR 1. Similarly, enable the campus fabric interconnect function on
Note
PxTR 2 and PxTR 3.
Verifying Campus Fabric Interconnect—MPLS L3VPN
You can verify MPLS configurations on a fabric border switch with these verification commands:

Verifying MPLS LDP Configuration

In the following example, you can verify MPLS LDP configuration:
PxTR1# show mpls ldp discovery
Local LDP Identifier:

Verifying MPLS LDP Neighbor Configuration

In the following example, you can verify MPLS LDP neighbor configuration:
PxTR1# show mpls ldp neighbor
Cisco Nexus 7000 Series NX-OS VXLAN Configuration Guide
94
send-community extended
exit
address-family ipv4 unicast
vrf vrf6000
address-family ipv4 unicast
redistribute lisp route-map LISP-RMAP
aggregate-address 198.51.0.0/16 summary-only
label-allocation-mode per-vrf
209.165.201.1:0
Discovery Sources:
Interfaces:
Ethernet2/20.1 (ldp): xmit/recv
LDP Id: 203.0.113.1:0
Peer LDP Ident: 203.0.113.1:0; Local LDP Ident 209.165.201.1:0
TCP connection: 203.0.113.1.646 - 209.165.201.1.63118
State: Oper; Msgs sent/rcvd: 69/71; Downstream
Up time: 00:53:49
LDP discovery sources:
Ethernet2/20.1, Src IP addr: 192.0.2.250
Addresses bound to peer LDP Ident:
203.0.113.1 172.16.0.1
Campus Fabric Interconnect - MPLS L3VPN
192.0.2.250 203.0.113.10