Viewing Predeployment Test Results - Novell ADMINSTUDIO 9.5 User Manual

Chapter 20: Analyzing Installations Prior to Deployment

Viewing Predeployment Test Results

2. Click Post Results. The results of the diagnostic tests are then listed in the Status window.
3. Review the results of the diagnostic tests. If you find an error message that could be resolved by making a
minor adjustment to your system, such as adjusting your server settings, you could make that adjustment and
click Post Results again. The Diagnostic Tool will run the diagnostic tests again (without having to launch the
test-ready package installation again) and generate new results. You can then check to see if your adjustment
fixed the problem.
4. When you have finished reviewing the results of the diagnostic tests, click Exit.
The installation of the test-ready package now finishes, and the results of the diagnostic tests are entered in
the Predeployment Test Web Service Application Catalog, and, if you specified the log option, into the log file.
Note • If an instrumented package is run in silent mode and
interface will not be displayed, but it will still run the diagnostic tests and write the results to the log file.
Viewing Predeployment Test Results
Use the View Predeployment Test Results link on the Predeployment Test Start Page to view the
Predeployment Test Results.
Task: To generate Predeployment Test results:
1. Launch the Predeployment Test tool. The Predeployment Test Start Page opens.
2. Select View Predeployment Test Results. The
browser, listing all of the test-ready packages that you have installed. All of the other reports can be accessed
from this report.
1556
PD_RUN_DIAGNOSTICS
Predeployment Test Results By Job Report
ADS-0950-UG00
is set, the Diagnostic Tool
opens in a Web
AdminStudio 9.5 User Guide