Novell ADMINSTUDIO 9.5 User Manual page 1485

Table 18-36 • Additional Parameters (cont.)
Parameter
/q [n|b|r|f]
/y <filename>
/z <filename>
TRANSFORMS
Properties
See Also
Preparing for ZENworks Configuration Management 10 Distribution
AdminStudio 9.5 User Guide
Chapter 18: Preparing Packages for Distribution Using Distribution Wizard
Description
The
/q
following flags:
•
q
• qb
The user interface settings below display a modal dialog box at the end of
installation:
•
qr
• qf
•
qn+
• qb+
This command calls the
or OCX file specified in
This command calls the
or OCX file specified in
Use the
you would like applied to your base package. Your transform command-line
call might look something like this:
msiexec /i "C:\Directory\ProductName.msi" TRANSFORMS="New Transform
1.mst"
You can separate multiple transforms with a semicolon. Because of this, it is
recommended that you do not use semicolons in the name of your
transform, as the Windows Installer service will interpret those incorrectly.
All public properties can be set or modified from the command line. Public
properties are distinguished from private properties by the fact that they are
in all capital letters. For example,
To set a property from the command line, use the following syntax:
PROPERTY=VALUE
If you wanted to change the value of
msiexec /i "C:\Directory\ProductName.msi" COMPANYNAME="YourCompany"
ADS-0950-UG00
option is used to set the user interface level in conjunction with the
or qn – Creates no user interface
– Creates a basic user interface
– Displays a reduced user interface
– Displays a full user interface
– Displays no user interface
– Displays a basic user interface
DllRegisterServer
<filename>
DllUnregisterServer
<filename
command-line parameter to specify any transforms that
TRANSFORMS
.
entry-point function of the DLL
.
entry-point function of the DLL
>.
is a public property.
COMPANYNAME
, you would enter:
COMPANYNAME
Reference
1485