Software Procedures; Backup And Restore; Creating A Backup Image Dvd; Restore From A Backup Image Dvd - Simrad SH90 - REFERENCE MANUAL REV A Reference Manual

Simrad SH90

Software procedures

60

Backup and restore

Software backup is provided using the following set of CDs and
DVDs.
• Processor Unit boot CD (allows the computer to boot)
• Processor Unit image (DVD) (generic, contains operating
system)
• Processor Unit image (DVD) (contains your own image
backup made during installation)
The image DVD provided with the Processor Unit is generic.
If you use this generic image, you must also activate the Windows
license within 30 days.
We strongly advice you to create your own backup DVD as
described in section Creating a backup image DVD on page 60.

Creating a backup image DVD

This procedure is used when you wish to create a backup DVD
containing your entire SH90 installation. The application used to
do the backup is
Norton Ghost 8
Note
To create the backup image, you need the
the sonar.
1 Connect a computer keyboard to one of the USB connectors
on the computer.
Power up the Processor Unit with the front mounted on/off
2
button (behind the lid).
3 Insert the
Boot CD
4 Observe the menu that appears on the display.
Remove the
5
Boot CD
At the prompt, press
6
C:
Follow the instructions provided. Allow the computer to
7
create the backup image, and burn it on the DVD.

Restore from a backup image DVD

This procedure is used when you wish to restore the SH90
software from a pre-made backup DVD containing your entire
installation. The image DVD may either be generic, or it may be
custom made to fit you system. The application used to restore
from the backup DVD is
.
Boot CD
, and allow the computer to boot from it.
, and insert a blank DVD.
, and then
1 Enter
.
Norton Ghost 8
provided with
.
323775/A