Xerox Phaser 3200MFP User Manual page 199

Display
Not Assigned
No Paper
Add Paper
Operation
Not Assigned
Out of Range
Open Front Door
Remove Paper
Open Rear Cover
Remove paper
Power Failure
Remove Documents
from ADF
Retry Redial?
Scanner Locked
Xerox Phaser 3200MFP
Meaning
The speed dial location
you tried to use has no
number assigned to it.
The ID you entered is
not assigned.
The paper in the tray
has run out.
You are doing the Add/
Cancel operation, but
there are no jobs
waiting.
The current date and
time you entered is not
correct.
Paper has jammed in
the feeding area of the
tray
Paper has jammed in
the fuser area or around
the print cartridge.
Paper has jammed in
the paper exit area.
Power has turned off
then on and the
machine's memory has
not been saved.
The Favorite Copy
button is set to Clone,
Autofit, ID Card Copy or
Poster and you press
the button.
The machine is waiting
for a specified time
interval to redial a
previously busy station.
The scanner module is
locked.
Suggested Solutions
Dial the number manually using
the number keypad or assign
the number. For storing a
Automatic
number, see
Dialing on page 8-13
Enter the correct ID. .
Load paper in the tray. See
Loading Paper on page 2-6
Check the display to see if there
are any scheduled jobs. The
display should indicate them in
Standby mode; for example,
Delay Fax.
Enter the correct date and time.
In the Tray
Clear the jam. See
on page 10-4
.
In the
Clear the jam. See
Fuser Area or Around the
Print Cartridge on page 10-5
In the
Clear the jam. See
Paper Exit Area. on page 10-
6
.
The job which you were trying to
do before the power failure
must be completely re-done.
The Clone, Autofit, ID Card
Copy or Poster feature does not
work with ADF. Remove the
documents in the ADF.
You can press Enter to
immediately redial, or Stop/
Clear to cancel the redial
operation.
Unplug the power cord and plug
it back in.
10 Troubleshooting
.
.
.
10-11