Envelopes With Double Side Seams; Envelopes With Adhesive Strips Or Flaps; Envelope Margins; Envelope Storage - Xerox Phaser 3200MFP User Manual

11 Specifications
11-12

Envelopes with Double Side Seams

Double side-seams construction has vertical seams at both ends of the
envelope rather than diagonal seams. This style may be more likely to wrinkle.
Be sure the seam extends all the way to the corner of the envelope as
illustrated below.
Correct
Incorrect

Envelopes with Adhesive Strips or Flaps

Envelopes with a peel-off adhesive strip or with more than one flap that folds
over to seal must use adhesives compatible with the heat and pressure in the
machine. The extra flaps and strips might cause wrinkling, creasing or even
jams and may even damage the fuser.

Envelope Margins

The following gives typical address margins for a commercial #10 or DL
envelope.
Type of Address
Return address
Delivery address
NOTE:
• For the best print quality, position margins no closer than 0.6 in. (15 mm)
from the edges of the envelope.
• Avoid printing over the area where the envelope's seams meet.

Envelope Storage

Proper storage of envelopes helps contribute to print quality. Envelopes
should be stored flat. If air is trapped in an envelope, creating an air bubble,
then the envelope may wrinkle during printing.
Minimum
0.6 in. (15 mm)
2 in. (51 mm)
Maximum
2 in. (51 mm)
3.5 in. (90 mm)
Xerox Phaser 3200MFP