Regulatory Information; Ce Mark; For Fax Function - Xerox Phaser 3200MFP User Manual

Regulatory Information

CE Mark

For Fax Function

Xerox Phaser 3200MFP
The CE mark applied to this product symbolizes Xerox's declaration of
conformity with the following applicable Directives of the European Union as
of the dates indicated:
December 12, 2006: Council Directive 2006/95/EEC amended by Council
Directive 93/68/EEC, approximation of the laws of the member states related
to low voltage equipment.
January 1, 1996: Council Directive 89/336/EEC, approximation of the laws of
the member states related to electromagnetic compatibility.
March 9, 1999: Council Directive 99/5/EC, on radio equipment and
telecommunications terminal equipment and the mutual recognition of their
conformity.
A full declaration of conformity, defining the relevant directives and referenced
standards, can be obtained from your Authorized local dealer.
WARNING:
In order to allow this equipment to operate in proximity to
Industrial Scientific and Medical (ISM) equipment, the external radiation
from the ISM equipment may have to be limited or special mitigation
measures taken.
WARNING:
Shielded interface cables must be used with this product to
maintain compliance with Council Directive 89/336/EEC.
USA
FAX Send Header Requirements:
The telephone Consumer Protection Act of 1991 makes it unlawful for any
person to use a computer or other electronic device, including a Fax machine,
to send any message unless such message clearly contains in a margin at the
top or bottom of each transmitted page or on the first page of the transmission,
the date and time it is sent and an identification of the business or other entity,
or other individual sending the message and the telephone number of the
sending machine or such business, other entity or individual. (The telephone
number provided may not be a 900 number or any other number for which
charges exceed local or long distance transmission charges.)
In order to program this information into your FAX machine refer to Setting the
Machine ID – page 2-15 and follow the steps provided. To enter the date and
time, please refer Setting the Date and Time – page 2-17.
1 Welcome
1-15