Xerox Phaser 3200MFP User Manual page 207

Xerox Phaser 3200MFP
Condition
Vertical lines If black vertical streaks appear on the page:
The drum inside the print cartridge has probably been
scratched. Remove the print cartridge and install a new one.
AaBbCc
AaBbCc Replacing the Print Cartridge on page 9-7
AaBbCc
AaBbCc
If white vertical streaks appear on the page:
AaBbCc
The surface of the LSU part inside the machine may be dirty.
Clean the LSU (
Contact a service representative.
Gray background If the amount of background shading becomes
unacceptable:
Change to a lighter weight paper.
AaBbCc
page 11-6
AaBbCc
AaBbCc
Check the machine's environment: very dry (low humidity) or
AaBbCc
high humidity (higher than 80% RH) conditions can increase
AaBbCc
the amount of background shading.
Remove the old print cartridge and install a new one.
Replacing the Print Cartridge on page 9-7
Toner smear Clean the inside of the machine.
page 9-3
Check the paper type and quality.
page 11-6
Parts of the machine may have toner on them. If defects
occur, the problem will likely correct itself after running five
(5) blank sheets.
Remove the print cartridge and install a new one.
the Print Cartridge on page 9-7
Vertical repetitive If marks repeatedly appear on the printed side of the page at
defects even intervals:
The print cartridge may be damaged. If a repetitive mark
AaBbCc
occurs on the page, print a cleaning sheet several times to
AaBbCc
clean the cartridge;
AaBbCc
the printout, if you still have the same problems, remove the
AaBbCc
print cartridge and install a new one.
AaBbCc
Cartridge on page 9-7
Parts of the machine may have toner on them. If defects
occur, the problem will likely correct itself after running five
(5) blank sheets.
The fusing assembly may be damaged. Contact a service
representative.
If you use inferior quality paper;
page 9-9
Suggested solutions
Cleaning the Inside on page 9-3
.
.
.
Cleaning the Drum on page 9-9
.
.
10 Troubleshooting
.
).
Paper Specifications on
.
Cleaning the Inside on
Paper Specifications on
Replacing
.
. After
Replacing the Print
Cleaning the Drum on
10-19