3 Network Setup
Introduction
Via the control panel
Supported operating systems
3-2
Once you have connected your machine to a network with an RJ-45 Ethernet
cable, you can share the machine with other network users.
You need to set up the network protocols on the machine to use it as your
network printer. Protocols can be set up by the following method:
You can set up the following basic network parameters through the machine's
control panel:
•
Configure TCP/IP
•
Configure EtherTalk
The following table shows the network environments supported by the
machine:
Item
Network interface •
Network
•
operating system
•
•
Network
•
protocols
•
Dynamic
•
addressing server
•
TCP/IP: Transmission Control Protocol/Internet Protocol
•
DHCP: Dynamic Host Configuration Protocol
•
BOOTP: Bootstrap Protocol
Requirements
10/100 Base-TX
Windows 98/Me/NT 4.0/2000/XP(32/64bit)/2003(32/
64bit)/Vista
Various Linux OS (refer to Installing the Unified Linux
Driver on page 32)
Macintosh OS 10.3~10.4
TCP/IP on Windows
EtherTalk
DHCP, BOOTP
Xerox Phaser 3200MFP