Refer to "Rear Panel Components" in Chapter 3 to identify connectors on the rear
panel of the rack server.
Securing the Power Cord
After you connect power cords to each AC power supply, use the power supply
retaining clips to secure the AC power cords. Form a service loop in the power cord
that is long enough to prevent the plug from being disengaged accidentally.
To secure the power cord:
1. Push the upper tab of the power supply retaining clip to release the cord loop (1).
2. Flip the lower tab down to open the cord loop (2).
Figure 4-13: Releasing the power cord retaining clip
HP ProLiant ML370 Generation 3 Server Setup and Installation Guide
Installing the Rack Server
4-15