HP 195294-001 - ProLiant - ML370R Setup And Installation Manual page 223

Table D-7: Problems After Initial Boot
Problem
Server cannot load
operating system.
HP ProLiant ML370 Generation 3 Server Setup and Installation Guide
continued
Possible Cause
Required operating
system step was
missed.
Installation problem
occurred.
Problem was
encountered with the
hardware you have
added to the server.
Problem was
encountered with
hardware added to a
new configure-to-order
server (where
available).
Possible Solution
Follow these steps:
1. Note at which phase the operating system
failed.
2. Remove any loaded operating system.
3. Refer to your operating system
documentation.
4. Install the operating system again.
Refer to your operating system documentation
and to the SmartStart Release Notes on the
SmartStart CD.
Run RBSU and check the OS Selection menu.
Refer to the documentation provided with the
hardware.
Refer to Chapter 6, "Server Cabling," to identify
correct SCSI cabling configuration for the server.
You must complete the factory-installed operating
system software installation before adding new
hardware to the server.
Be sure you are following the instructions provided
in the Factory-Installed Operating System
Software Installation Guide.
Remove the new hardware and complete the
software installation. Then, reinstall the new
hardware.
Troubleshooting
D-15