HP 195294-001 - ProLiant - ML370R Setup And Installation Manual page 97

Installing Hardware Options
9. Connect the power cable to the hard drive (1).
IMPORTANT: SCSI port 2 on the system board and the external VHDCI SCSI connector
on the rear panel are on the same SCSI channel. This channel supports either internal or
external devices, but not both types of devices at the same time. Disconnect external
devices from the external VHDCI SCSI connector before connecting an internal device to
SCSI port 2 (or the reverse).
10. Connect the three-device SCSI cable to the hard drive and SCSI port 2 on the
system board (2).
Figure 3-42: Connecting the power and signal cables for
a non-hot-plug hard drive
11. Slide the hard drive fully into the bay until it is seated securely.
3-52 HP ProLiant ML370 Generation 3 Server Setup and Installation Guide