HP 195294-001 - ProLiant - ML370R Setup And Installation Manual page 98

12. Reinstall the following items:
— CD-ROM drive, if needed
— Center wall
— Expansion boards
— Processor air baffle
— Bezel blanks
NOTE: If the second media bay is already populated with an optional drive, store the
extra bezel blank for later use.
13. Install other hardware options as needed or reinstall the access panel.
14. Power up the server.
Installing a Half-Height or Full-Height Media Device
You can install up to two half-height or one full-height removable devices in the
removable media cage. To install a half-height or full-height media device:
1. Power down the server. Refer to "Powering Down the Server" in this chapter.
2. Remove the access panel. Refer to "Removing the Access Panel" in this chapter.
3. Access the removable media cage. Refer to "Accessing the Removable Media
Cage" in this chapter.
NOTE: HP recommends that you remove all bezel blanks to facilitate drive installation.
HP ProLiant ML370 Generation 3 Server Setup and Installation Guide
Installing Hardware Options
3-53