HP 195294-001 - ProLiant - ML370R Setup And Installation Manual page 82

IMPORTANT: DIMMs must be installed in pairs so that both slots in the bank are
populated with identical DIMMs.
4. Open the DIMM slot latches (1).
5. Align the key slot in the bottom edge of the DIMM with the tab in the slot (2).
Figure 3-28: Installing a DIMM in a DIMM slot
IMPORTANT: DIMMs do not seat if turned the wrong way.
6. Press down evenly on the DIMM until it is seated securely in the slot and the
latches close.
7. Repeat steps 4 and 5 to install the second DIMM in the pair.
8. Install other hardware options or replace the access panel before powering up the
server.
If you are installing DIMMs for the online spare configuration, use RBSU to
configure this feature. Refer to Chapter 7, "Server Configuration and Utilities," for
additional information.
HP ProLiant ML370 Generation 3 Server Setup and Installation Guide
Installing Hardware Options
3-37