Optional Internal Two-Bay Hot-Plug Scsi Drive Cage - HP 195294-001 - ProLiant - ML370R Setup And Installation Manual
Hp proliant ml370 generation 3 setup and installation guide
Hide thumbs
Also See for 195294-001 - ProLiant - ML370R:
- Reference manual (138 pages) ,
- Configuration manual (2 pages) ,
- Installation instructions manual (15 pages)
Table of Contents
Advertisement
10. Reinstall the following items:
— CD-ROM drive, if needed
— Center wall
— Expansion boards
— Processor air baffle
— Bezel blanks
NOTE: If the second media bay is populated with an optional drive, store the extra bezel
blank for later use.
11. Install other hardware options as needed or reinstall the access panel.
12. Power up the server.
Optional Internal Two-Bay Hot-Plug SCSI Drive Cage
To install an optional internal two-bay hot-plug SCSI drive cage into the removable
media bay:
NOTE: For additional information about the two-bay hot-plug SCSI drive cage, refer to the HP
Internal Two-Bay Hot-Plug SCSI Drive Cage Installation Instructions.
1. Power down the server. Refer to "Powering Down the Server" in this chapter.
2. Remove the access panel. Refer to "Removing the Access Panel" in this chapter.
3. Access the removable media cage by removing the following items:
— bezel blanks
— processor air baffle
— expansion boards
— center wall
4. Refer to "Accessing the Removable Media Cage" in this chapter.
HP ProLiant ML370 Generation 3 Server Setup and Installation Guide
Installing Hardware Options
3-57
Advertisement
Table of Contents
