HP 195294-001 - ProLiant - ML370R Setup And Installation Manual page 111
Hp proliant ml370 generation 3 setup and installation guide
Hide thumbs
Also See for 195294-001 - ProLiant - ML370R:
- Reference manual (138 pages) ,
- Configuration manual (2 pages) ,
- Installation instructions manual (15 pages)
Table of Contents
Advertisement
Installing Hardware Options
To replace a hot-plug fan:
1. Squeeze the hot-plug fan handles together (1).
2. Lift the fan out of the fan cage (2).
Figure 3-56: Removing a hot-plug fan
3. Slide the replacement hot-plug fan into the open fan cage slot and press down to
seat the fan securely.
4. Repeat steps 1 through 3 to replace additional fans as needed.
5. Reinstall the access panel.
6. Power up the server and observe the internal system health LED on the front
panel and the LEDs on all installed fans to be sure they are green.
NOTE: If the front panel internal system health LED is not green after you install hot-plug
fans, reseat the hot-plug fan or refer to Appendix D, "Troubleshooting," for diagnosis.
3-66
HP ProLiant ML370 Generation 3 Server Setup and Installation Guide
Advertisement
Table of Contents
