Front And Rear Uid Switch And Led Locations - HP 195294-001 - ProLiant - ML370R Setup And Installation Manual

Installing Hardware Options
Figure 3-13: Front and rear UID switch and LED
locations (rack server)
Table 3-8: Front and Rear UID Switch and LED
Locations
Item Description
1 Front panel UID switch and LED
2 Rear panel UID switch and LED
4. Press the Power On/Standby button.
5. The Power On/Standby LED turns amber when the server is powered down in
this manner, indicating that auxiliary power is still present in the system. When
you remove power from the system completely by removing all power cords, the
LED turns off.
3-16
WARNING: Pressing the Power On/Standby button to power down the
server removes power from most areas of the server. This process may
take 30 seconds. Portions of the power supply and some internal circuitry
remain active until the AC power cord is disconnected.
If the server has multiple power supplies installed, it is necessary to
remove all power cords to remove all power from the system.
HP ProLiant ML370 Generation 3 Server Setup and Installation Guide