HP 195294-001 - ProLiant - ML370R Setup And Installation Manual page 101

Installing Hardware Options
7. Connect the four-pin power cable to the half-height or full-height drive (1).
IMPORTANT: SCSI port 2 on the system board and the external VHDCI SCSI connector
on the rear panel are on the same SCSI channel. This channel supports either internal or
external devices, but not both types of devices at the same time. Disconnect external
devices from the external VHDCI SCSI connector before connecting an internal device to
SCSI port 2 (or the reverse).
8. Connect the three-device SCSI cable to the half-height or full-height drive and
SCSI port 2 on the system board (2).
Figure 3-46: Connecting the power and signal cables for
a tape drive
9. Slide the media drive fully into the bay until it is seated securely.
3-56 HP ProLiant ML370 Generation 3 Server Setup and Installation Guide