Removing A Hard Drive Blank - HP 195294-001 - ProLiant - ML370R Setup And Installation Manual
Hp proliant ml370 generation 3 setup and installation guide
Hide thumbs
Also See for 195294-001 - ProLiant - ML370R:
- Reference manual (138 pages) ,
- Configuration manual (2 pages) ,
- Installation instructions manual (15 pages)
Table of Contents
Advertisement
Installing Hardware Options
Removing a Hard Drive Blank
The server ships standard with six hot-plug hard drive blanks. Before installing a
hot-plug SCSI hard drive, you must remove a blank.
CAUTION: Always populate drive bays with either a hard drive or blank. Proper
airflow can only be maintained when the bays are populated. Operating the server
with unpopulated drive bays can lead to improper cooling and thermal damage.
To remove a hard drive blank:
1. Grab the two thumb tabs and squeeze them together to release the blank (1).
2. Pull the blank out of the drive bay (2).
Figure 3-31: Removing a hard drive blank
3. Store the hard drive blank for later use.
To install a blank, align the blank with the empty bay and push the blank inward until
it locks into place.
3-40
HP ProLiant ML370 Generation 3 Server Setup and Installation Guide
Advertisement
Table of Contents
