HP 195294-001 - ProLiant - ML370R Setup And Installation Manual page 181

Server Configuration and Utilities
•
Set CPU Corrected—allows you to change the status of the selected processor
to "corrected" after a processor failure. Only perform this step after the failed
processor has been replaced.
•
Wake on LAN—allows you to enable or disable Wake on LAN support (PME).
The default for this setting is disabled.
•
Fan Speed—allows you to configure the default fan speed. The health driver
overrides the default setting when loading the operating system to allow
maximum flexibility and protection. Settings include:
— High—sets the fan speed on high to provide maximum thermal protection.
The default for this setting is disabled.
— Normal—sets the fan speed on low for minimum acoustic output. The
default for this setting is enabled.
•
NMI Debug Button—allows you to enable or disable the NMI debug button.
The default is enabled.
•
Custom POST Message—allows you to display a custom message during
POST.
•
Processor Hyper-Threading—allows you to enable or disable processor
Hyper-Threading. The default is enabled.
BIOS Serial Console
The BIOS Serial Console menu option allows you to view POST error messages and
run RBSU remotely through a serial connection to the server COM port. A keyboard
and monitor on the machine that you are remotely configuring are not required. For
more information about BIOS Serial Console, refer to the BIOS Serial Console User
Guide.
7-8
CAUTION: Always configure the fan speed control for high speed in
high-altitude environments or in fully loaded systems. For maximum protection,
always load the health driver.
HP ProLiant ML370 Generation 3 Server Setup and Installation Guide