Hardware Options Installation
Installing a Two-Bay Hot-Plug SCSI Drive Cage
NOTE: For additional information about the two-bay hot-plug SCSI drive cage, refer to the HP
Internal Two-Bay Hot-Plug SCSI Drive Cage Installation Instructions.
To install the two-bay hot-plug SCSI drive cage:
1. Complete the "Preparation Procedures" in this chapter.
2. Remove the bezel that ships attached to the drive cage:
a. Use a Torx T-10 tool to loosen the two screws.
b. Remove the screws from the bezel.
c. Remove the bezel from the drive cage.
IMPORTANT: Be sure that the unit identification numbers (0 and 1) appear on the right
side of the drive cage front panel. For identification purposes, the number 2 appears on
the back of the bezel shipped with the option kit.
3. Reverse the actions in step 1 to install the smaller bezel from the option kit on the
drive cage.
4-22
HP ProLiant ML330 Generation 3 Server Setup and Installation Guide