Removing A 5 1/4-Inch Device From The Lowest Bay; Removing The Accessible Device Cage; Removing A 5 1/4-Inch Device From An Upper Bay - NEC PowerMate Professional 9000E Series Service Manual

Removing a 5 1/4-Inch Device From an Upper Bay

Removing a 5 1/4-Inch Device from the Lowest Bay

Use the following procedure to remove a 5 1/4-inch device from the lowest of
the three 5 1/4-inch accessible device bays. If you are removing a device from
one of the upper two 5 1/4-inch bays, see "Removing a 5 1/4-Inch Device from
an Upper Bay."
1. Follow all directions on removing the 5 1/4-inch accessible device cage (see

"Removing the Accessible Device Cage").

2. Remove the four screws (two to a side) securing the device in the lowest bay
of the accessible device cage.
3. Slide the device out of the bay.
Removing the Accessible Device Cage
Remove the 5 1/4-inch accessible device cage by following these steps.
1. Remove both side covers and the top cover of the system unit (see
"Removing the Side Covers" and "Removing the Top Cover").
2. Remove the front panel (see "Front Panel Removal").
3. Label and disconnect all cables going to devices in the 5 1/4-inch accessible
device cage.
4. Remove the seven screws securing the 5 1/4-inch accessible device cage to
the chassis (see the figure on the following page).
Disassembly and Reassembly 3-13