System Board Jumper Settings - NEC PowerMate Professional 9000E Series Service Manual

Interrupt
IRQ4
IRQ5
IRQ6
IRQ7
IRQ8_L
IRQ9
IRQ10
IRQ11
IRQ12
IRQ14
IRQ15
PCI_INTA_L
PCI_INTB_L
PCI_INTC_L
PCI_INTD_L

System Board Jumper Settings

Jumpers on the system board are used to set the system configuration. Functions
that are configured by jumper settings include:
T
BMC forced update mode
T
chassis intrusion detection
T
FRB timer enable
T
boot block write protect
T
recovery boot
T
password clear
T
CMOS clear
T
BMC bootblock write protect
T
Wake-On LAN enable
Interrupt Level Assignments
I/O APIC level Description
INT4 Serial port A or B interrupt from 87309VLJ device (user
can configure)
INT5 Open for use
INT6 Diskette
INT7 Parallel port
INT8 RTC interrupt
INT9 Reserved for SCI (ACPI)
INT10 Open for use
INT11 Open for use
INT12 Mouse interrupt
INT13
INT14 Compatibility IDE interrupt from primary channel IDE
devices 0 and 1
INT15 Secondary IDE interrupt
INT16 PCI Interrupt signal A
INT17 PCI Interrupt signal B
INT18 PCI Interrupt signal C
INT19 PCI Interrupt signal D
System Configuration 2-3