Bios Setup Utility; Accelstar Ii Video Modes - NEC PowerMate Professional 9000E Series Service Manual

Resolution (pixels)/
Vertical Refresh
Rate (Hz)
640 x 480
60, 72, 75, 85, 100
800 x 600
60, 75, 85, 100
1024 x 768
1152 x 870
60, 75, 85, 100
1280 x 1024
60, 75, 85, 100
* BPP = Bits Per Pixel
** 256 color texture mapping is not recommended
*** Acceleration is set to 24-bitmoode, but 3D rendering is actually in 16-bitmode

BIOS Setup Utility

The BIOS Setup utility configures system parameters. The parameters are saved
in nonvolatile memory in a CMOS chip backed by a battery on the system
board. The battery supplies continuous power to maintain parameter
configuration information when system power is off.
Note:
battery, print out or write down the current setup parameter
settings and store in a safe place. Use this information to
restore the system to the current parameters if a wrong
setting is made or if the battery needs replacement (see
Section 3 for battery replacement).
2-6 System Configuration

AccelSTAR II Video Modes

Buffers
Color S=Single
Depth* D=Double
256 S
256 S or D
32K S or D
16.7m S
(true color)
265 S or D
32K S or D
16.7M S or D***
(true color)
265 S or D
32K, 65K S or D
16.7M S
(true color)
256 S
Before changing parameters or replacing the
Available Texture Mapping Memory
in Double Buffered Mode
Not Available
5 MB**
5 MB
Not Available
5 MB**
3.5 MB @ 1024
2 MB @ 1152
Not Available
3 MB**
0.5 MB
Not Available
Not Available