Zeiss Axiovert 5 Instruction Manual page 89

ZEISS
5.3.3.3 Switching Off the Light Manager Function
To switch off the LM function proceed as follows:
Procedure 1. Press one of the Snap buttons and the Inten-
5.3.4 Activating the ECO/Permanent Mode
ü
Prerequisite
Procedure 1. Select the ECO or Permanent mode for micro-
5.3.5 Setting the Parfocal Alignment
The present section applies to the following microscope types:
§
§
NOTICE
Collision of the objective with the sample due to incorrect setting
The objective can collide with the sample and damage the microscope if the parfocal align-
ment procedure was performed incorrectly.
4
ü
Prerequisite
ü
Procedure 1. Press the left Snap button and the Intensity/LM knob simultaneously for > 8 s.
Instruction Manual ZEISS Axiovert 5, Axiovert 5/7 materials | en-US | Rev. 6 | 431030-7011-101
sity/LM knob simultaneously for at least
1.5 seconds.
à
The indicator light blinks in the following sequence: GREEN/ORANGE/GREEN.
The microscope is operational.
scope illumination using the
mode switch.
Axiovert 7 RL
Axiovert 7 RL TL
Follow the described setting procedure.
The microscope is operational.
The Light Manager function is switched on.
à
The LED indicator turns to red.
à
The Parfocality alignment mode is activated.
ECO/Permanent
5 Operation | 5.3 Adjusting
89