Zeiss Axiovert 5 Instruction Manual page 14

2 Safety | 2.3 Prevention of Hazards
Detachable The microscope can be equipped with different detachable reflected or fluorescence light sources.
Light Sources The optical radiation risk group according to IEC 62471 for those detachable light source ranges
from risk group 2 to risk group 3. They will all degrade to risk group 0 or risk group 1 while inte-
gration into the system. Optical radiation may cause damage to the skin and eyes.
§
§
The following table lists the risk grouping of the available light sources/illumination units accord-
ing to the mentioned standard:
Light source/Illumination unit
Axiovert 5/7 stand (illuminator TL LED 10 W
integrated)
Illuminator RL LED 10 W
HAL 100
HXP 120
HBO 50
Colibri 3
X-Cite Xylis
2.3 Prevention of Hazards
This section summarizes potential hazards and recommended safety precautions. Failure to follow
the safety instructions and instructions may result in personal injury and property damage.
2.3.1 Mechanical Hazards
Crushing The microscope contains motorized components. Fingers could be trapped. Do not reach into the
Hazards due to working area of motorized components when they are in operation.
Motorized
Components
Crushing The toppling and falling of the microscope may cause injuries to the user. Only operate the micro-
Hazards due to scope on a stable working table with a solid and smooth tabletop.
Unstable
Working Table
Property There is a risk of injury and property damage if the microscope is improperly handled and trans-
Damage due to ported.
Transport
§
2.3.2 Electrical Hazards
Voltage Hazards Risk of electric shock in case of contact with live parts.
§
§
§
§
14
Make sure the microscope is switched off while assembling/disassembling the light sources.
Avoid exposure of eyes and skin to radiation.
Only use the handle, if applicable, for transport of the microscope. Otherwise hold the micro-
scope with one hand and the base plate with the other hand.
Detachable mains supply cords must not be replaced with inadequately rated cords.
Disconnect all power cords before cleaning.
Only connect electrical systems that are authorized by ZEISS to the supplied power supply
cord.
Set up and operate the microscope so that the connectors are easily accessible.
Instruction Manual ZEISS Axiovert 5, Axiovert 5/7 materials | en-US | Rev. 6 | 431030-7011-101
Risk group
2 (moderate risk)
2 (moderate risk)
2 (moderate risk)
2 (moderate risk)
3 (high risk)
3 (high risk)
3 (high risk)
ZEISS