Zeiss Axiovert 5 Instruction Manual page 164

10 Accessories and Optional System Expansions | 10.6 External Light Sources
ü
Prerequisite
ü
ü
Procedure
1. Press the release button
2. Put the bulb replacement tool
3. Press down the two spring levers
4.
5. Press down the two spring levers and insert the new bulb into the bulb socket
6. To center the bulb, briefly press the spring levers once more.
7.
10.6.2 HBO 50 Light Source
Purpose The HBO 50 light source serves as a light source for the reflected light process using a fluores-
cence lamp.
Position The HBO 50 is installed on the reflected light port on the backside of the stand.
1
2
Fig. 65: HBO 50
1
3
5
7
10.6.2.1 Assembling the HBO 50 Light source

Parts and Tools
ü
Prerequisite
ü
Procedure 1. At the illumination mount on the rear side of the stand, loosen the clamping screw.
2. Remove the protective cap.
3. Insert the light source's dovetail ring into the illumination mount.
4. Fasten the clamping screw.
164
The microscope is switched off.
The plug of the light source's cable has been removed from the corresponding socket.
The light source has cooled down for about 15 minutes.
tion.
NOTICE Do not touch the new bulb with bare hands!
Put the bulb replacement tool onto the replacement bulb
NOTICE Do not leave the bulb replacement tool inside the light source.
Insert the lamp carrier into the Hal 100 housing
Power supply unit (PSU)
Lamp housing
Vertical adjustment screw
Horizontal adjustment screw
Hex Key, 3.0 mm
The microscope is switched off.
The HBO 50 light source is switched off.
Instruction Manual ZEISS Axiovert 5, Axiovert 5/7 materials | en-US | Rev. 6 | 431030-7011-101
7
and pull the bulb carrier
2
onto the old bulb
4
and remove the tool with the bulb in upward direc-
1
3 4
2
4
6
8
6
completely out to the side.
3
.
5
.
and slide it in until it clicks into place.
5 6
Main switch
Dovetail ring
Adjustment screw
Unlocking button
ZEISS
8
.
7 8