Zeiss Axiovert 5 Instruction Manual page 12

2 Safety | 2.2 General Safety Information
2.2 General Safety Information
This document must be read before commissioning in order to ensure safe and uninterrupted op-
eration. Pay particular attention to all listed safety notes. Make sure, that
§
§
§
§
§
§
2.2.1 Requirements for Operators
The microscope, components, and accessories may only be operated and maintained by autho-
rized and trained personnel. The microscope may only be used in accordance with this document.
If the microscope is not used as described, the safety of the user may be impaired and/or the mi-
croscope may be damaged.
Any unauthorized intervention or use other than within the scope of the intended use shall void
all rights to warranty claims. The regional regulations on health protection and accident preven-
tion must be observed at all times and during all work on and with the microscope.
2.2.2 Safe Operating Condition
If circumstances occur which impair safety and cause changes in operating behavior, the micro-
scope and its components must be shut down immediately and a ZEISS service representative
should be informed.
The microscope and its components may only be operated after correct installation by a ZEISS ser-
vice representative and if the operating conditions are adhered to.
§
§
§
2.2.3 EMC Information
2.2.3.1 Axiovert 5
The following EMC information is valid for the Axiovert 5 microscopes. For a definition of the in-
cluded microscopes, see Intended Purpose [
The microscope is intended to be used in an industrial electromagnetic environment for non-clini-
cal applications or in a home healthcare environment for clinical applications.
Use of this microscope in a dry environment, especially if synthetic materials are present (synthetic
clothing, carpets, etc.), may cause electrostatic discharges that may cause erroneous results.
Do not use the microscope in proximity to sources of strong electromagnetic radiation, as these
can interfere with proper operation.
12
the operating personnel has read and understood this manual, associated documents and
particularly all safety regulations and instructions, and applies them.
the local and national safety and accident prevention regulations must be observed, as well as
the applicable laws and regulations in your country.
this document is always available at the place of use of the microscope.
the microscope is always in perfect condition.
in case of defect or damage, the affected parts and the microscope are taken out of opera-
tion immediately and are secured against unintentional use.
maintenance and repair work, retrofitting, removal or replacement of components, as well as
any other intervention in the microscope not described in this document, may only be carried
out by the manufacturer ZEISS or persons expressly authorized by ZEISS to do so.
Do not operate the microscope and its components until you have completely read and un-
derstood the entire documentation.
Make sure that all protective cover panels are installed and all warning labels are available and
legible.
Ensure conditions and take measures to prevent the build up of electrostatic charge on the
workplace.
Instruction Manual ZEISS Axiovert 5, Axiovert 5/7 materials | en-US | Rev. 6 | 431030-7011-101
}
11].
ZEISS