ZyXEL Communications NXC5200 User Manual page 599

Table 229 Interface Logs (continued)
LOG MESSAGE
AUX Interface
disconnecting failed.
This AUX interface is
not enabled.
Please type phone
number of interface
AUX first then dial
again.
Please type phone
number of Interface
AUX first then
disconnect again.
Interface %s will
reapply because Device
HA become active
status.
Interface %s will
reapply because Device
HA is not running.
Interface %s will stop
connect because Device
HA become standby
status.
Create interface %s
has been failed.
Base interface %s is
disabled. Interface %s
is disabled now.
Interface %s has been
changed.
Interface %s has been
added.
Interface %s is
enabled.
Interface %s is
disabled.
%s MTU > (%s MTU - 8),
%s may not work
correctly.
(%s MTU - 8) < %s MTU,
%s may not work
correctly.
NXC5200 User's Guide
DESCRIPTION
The AUX interface is not enabled and a user tried to use the
disconnect aux command.
A user tried to dial the AUX interface, but the AUX interface
does not have a phone number set.
The AUX interface does not have a phone number set and a
user tried to use the disconnect aux command.
Device-ha became active and is using a PPP base interface,
the PPP interface must reapply, %s is the interface name.
Device-ha was deleted and free PPP base interface, PPP
interface must reapply, %s is the interface name.
When device-ha is stand-by and use PPP base interface, PPP
interface connection will stop, %s: interface name.
When PPP can't running fail, %s: interface name.
When user disable ethernet, vlan or bridge interface and this
interface is base interface of PPP or virtual interface. PPP and
virtual will disable too. 1st %s is interface name, 2nd %s is
interface.
An administrator changed an interface's configuration. %s:
interface name.
An administrator added a new interface. %s: interface name.
An administrator enabled an interface. %s: interface name.
An administrator disabled an interface. %s: interface name.
An administrator configured a PPP interface, PPP interface
MTU > (base interface MTU - 8), PPP interface may not run
correctly because PPP packets will be fragmented by base
interface and the peer will not receive correct PPP packets.
1st %s: PPP interface name, 2nd %s: ethernet interface
name.
An administrator configured ethernet, vlan or bridge and this
interface is base interface of PPP interface. PPP interface MTU
> (base interface MTU - 8), PPP interface may not run
correctly because PPP packets will be fragmented by base
interface and peer will not receive correct PPP packets.1st
%s: Ethernet interface name, 2nd %s: PPP interface name.
Appendix A Log Descriptions
599