ZyXEL Communications NXC5200 User Manual page 264

Chapter 18 Firewall
Table 95 Configuration > Firewall > Session Limit > Add/Edit (continued)
LABEL
Description
User
Address
Session Limit
per Host
OK
Cancel
264
DESCRIPTION
Enter information to help you identify this rule. Use up to 64 printable
ASCII characters. Spaces are allowed.
Select a user name or user group to which to apply the rule. The rule is
activated only when the specified user logs into the system and the rule
will be disabled when the user logs out.
Otherwise, select any and there is no need for user logging.
Note: If you specified an IP address (or address group) instead of
any in the field below, the user's IP address should be within
the IP address range.
Select a source address or address group for whom this rule applies.
Select any if the policy is effective for every source address.
Use this field to set a limit to the number of concurrent NAT/firewall
sessions this rule's users or addresses can have.
For this rule's users and addresses, this setting overrides the Default
Session per Host setting in the general Firewall Session Limit
screen.
Click OK to save your customized settings and exit this screen.
Click Cancel to exit this screen without saving.
NXC5200 User's Guide