ZyXEL Communications NXC5200 User Manual page 498

Chapter 33 System
To change your NXC's FTP settings, click Configuration > System > FTP tab.
The screen appears as shown. Use this screen to specify from which zones FTP can
be used to access the NXC. You can also specify from which IP addresses the
access can come.
Figure 233 Configuration > System > FTP
The following table describes the labels in this screen.
Table 188 Configuration > System > FTP
LABEL
Enable
TLS required
Server Port
Server
Certificate
Service
Control
Add
Edit
498
DESCRIPTION
Select the check box to allow or disallow the computer with the IP
address that matches the IP address(es) in the Service Control table to
access the NXC using this service.
Select the check box to use FTP over TLS (Transport Layer Security) to
encrypt communication.
This implements TLS as a security mechanism to secure FTP clients and/
or servers.
You may change the server port number for a service if needed, however
you must use the same port number in order to use that service for
remote management.
Select the certificate whose corresponding private key is to be used to
identify the NXC for FTP connections. You must have certificates already
configured in the My Certificates screen.
This specifies from which computers you can access which NXC zones.
Click this to create a new entry. Select an entry and click Add to create a
new entry after the selected entry.
Double-click an entry or select it and click Edit to be able to modify the
entry's settings.
NXC5200 User's Guide