ZyXEL Communications NXC5200 User Manual page 511

The following table describes the labels in this screen.
Table 194 Configuration > Log & Report > Log Setting > Edit
LABEL
E-Mail Server 1/2
Active
Mail Server
Mail Subject
Send From
Send Log To
Send Alerts To
Sending Log
Day for Sending
Log
Time for Sending
Log
SMTP
Authentication
User Name
Password
Active Log and Alert
System log
NXC5200 User's Guide
DESCRIPTION
Select this to send log messages and alerts according to the
information in this section. You specify what kinds of log messages
are included in log information and what kinds of log messages are
included in alerts in the Active Log and Alert section.
Type the name or IP address of the outgoing SMTP server.
Type the subject line for the outgoing e-mail.
Type the e-mail address from which the outgoing e-mail is
delivered. This address is used in replies.
Type the e-mail address to which the outgoing e-mail is delivered.
Type the e-mail address to which alerts are delivered.
Select how often log information is e-mailed. Choices are: When
Full, Hourly and When Full, Daily and When Full, and Weekly
and When Full.
This field is available if the log is e-mailed weekly. Select the day of
the week the log is e-mailed.
This field is available if the log is e-mailed weekly or daily. Select
the time of day (hours and minutes) when the log is e-mailed. Use
24-hour notation.
Select this check box if it is necessary to provide a user name and
password to the SMTP server.
This box is effective when you select the SMTP Authentication
check box. Type the user name to provide to the SMTP server when
the log is e-mailed.
This box is effective when you select the SMTP Authentication
check box. Type the password to provide to the SMTP server when
the log is e-mailed.
Use the System Log drop-down list to change the log settings for
all of the log categories.
disable all logs (red X) - do not log any information for any
category for the system log or e-mail any logs to e-mail server 1 or
2.
enable normal logs (green check mark) - create log messages
and alerts for all categories for the system log. If e-mail server 1 or
2 also has normal logs enabled, the NXC will e-mail logs to them.
enable normal logs and debug logs (yellow check mark) -
create log messages, alerts, and debugging information for all
categories. The NXC does not e-mail debugging information, even if
this setting is selected.
Chapter 34 Log and Report
511