ZyXEL Communications NXC5200 User Manual page 190

Chapter 11 Interfaces
Table 66 Configuration > Network > Interface > VLAN > Add/Edit (continued)
LABEL
Interface
Name
VID
Zone
Description
Member
Configuration
Edit
#
#
Member
Tx Tagging
IP Address
Assignment
Get
Automatically
Use Fixed IP
Address
IP Address
Subnet Mask
Gateway
Metric
Related Setting
190
DESCRIPTION
This field is read-only if you are editing an existing VLAN interface.
Enter the number of the VLAN interface. You can use a number from
0~4094. For example, vlan0, vlan8, and so on.
Enter the VLAN ID. This 12-bit number uniquely identifies each VLAN.
Allowed values are 1 - 4094. (0 and 4095 are reserved.)
Select the zone to which the VLAN interface belongs.
Enter a description of this interface. It is not used elsewhere. You can
use alphanumeric and
()+/:=?!*#@$_%-
up to 60 characters long.
Use these settings to assign interfaces to this VLAN as members.
Click this to edit the selected interface's membership values.
This is sequential indicator of the interface number.
This indicates the interface name.
This indicates whether the selected interface is a member or not of
the VLAN which is currently being edited.
Click this field to edit the value.
This indicates whether the selected interface tags outbound traffic
with this VLAN's ID .
Click this field to edit the value.
Select this if this interface is a DHCP client. In this case, the DHCP
server configures the IP address, subnet mask, and gateway
automatically.
Select this if you want to specify the IP address, subnet mask, and
gateway manually.
This field is enabled if you select Use Fixed IP Address.
Enter the IP address for this interface.
This field is enabled if you select Use Fixed IP Address.
Enter the subnet mask of this interface in dot decimal notation. The
subnet mask indicates what part of the IP address is the same for all
computers in the network.
This field is enabled if you select Use Fixed IP Address.
Enter the IP address of the gateway. The NXC sends packets to the
gateway when it does not know how to route the packet to its
destination. The gateway should be on the same network as the
interface.
Enter the priority of the gateway (if any) on this interface. The NXC
decides which gateway to use based on this priority. The lower the
number, the higher the priority. If two or more gateways have the
same priority, the NXC uses the one that was configured first.
characters, and it can be
NXC5200 User's Guide