Service Control Rules; Https Example - ZyXEL Communications NXC5200 User Manual

Hide thumbs Also See for NXC5200:

Table of Contents

33.6.5 Service Control Rules

Click Add or Edit in the Service Control table in a WWW, SSH, Telnet, FTP or

SNMP screen to add a service control rule.

Figure 222 Configuration > System > Service Control Rule > Add/Edit

The following table describes the labels in this screen.

If you haven't changed the default HTTPS port on the NXC, then in your browser

enter "https://NXC IP Address/" as the web site address where "NXC IP Address"

is the IP address or domain name of the NXC you wish to access.

NXC5200 User's Guide

Configuration > System > Service Control Rule > Add/Edit

Use this to configure any new settings objects that you need to use in

this screen.

Select ALL to allow or deny any computer to communicate with the NXC

using this service.

Select a predefined address object to just allow or deny the computer

with the IP address that you specified to access the NXC using this

Select ALL to allow or prevent any NXC zones from being accessed using

this service.

Select a predefined NXC zone on which a incoming service is allowed or

Select Accept to allow the user to access the NXC from the specified

Select Deny to block the user's access to the NXC from the specified

Click OK to save your customized settings and exit this screen.

Click Cancel to exit this screen without saving

Chapter 33 System

Nxc5200 - v2.20