ZyXEL Communications NXC5200 User Manual page 521

Note: "exit" or "!'" must follow sub commands if it is to make the NXC exit sub
command mode.
Line 3 in the following example exits sub command mode.
interface ge1
ip address dhcp
!
Lines 1 and 3 in the following example are comments and line 4 exits sub
command mode.
!
interface ge1
# this interface is a DHCP client
!
Lines 1 and 2 are comments. Line 5 exits sub command mode.
! this is from Joe
# on 2008/04/05
interface ge1
ip address dhcp
!
Errors in Configuration Files or Shell Scripts
When you apply a configuration file or run a shell script, the NXC processes the file
line-by-line. The NXC checks the first line and applies the line if no errors are
detected. Then it continues with the next line. If the NXC finds an error, it stops
applying the configuration file or shell script and generates a log.
You can change the way a configuration file or shell script is applied. Include
setenv stop-on-error off in the configuration file or shell script. The NXC
ignores any errors in the configuration file or shell script and applies all of the valid
commands. The NXC still generates a log for any errors.
NXC5200 User's Guide
Chapter 35 File Manager
521