GRAPHTEC miid LOGGER GL860 User Manual page 7

Thank you for purchasing the GL860 midi LOGGER.
Please read this manual thoroughly before attempting to use your new product to ensure that you use it correctly and to
its full potential.
Notes on Use
Be sure to read all of the following notes before attempting to use the GL860 midi LOGGER.
1. Note on the CE Marking
The GL860 midi LOGGER complies with the following standards.
• EN 61326-1 standard is based on the EMC Directive
• EN 61010-1 standard is based on the Low Voltage Directive (LVD)
• EN 301 489-17/-1, EN 300 328 standards are based on the Radio Equipment Directive (RED)
(Use optional B-568)
Although the GL860 complies with the above-mentioned standards, be sure to use it correctly in
accordance with the instructions and notes provided in this manual.
Moreover, the use of the GL860 by incorrect procedures may result in damage to the GL860 or may
invalidate its safeguards.
Please confirm all of its notes regarding use and other related information to ensure correct use.
Information of Regulation (EU) 2023/1542
The manufacturer information of the Lithium Rechargeable Battery mounted on the internal board of the
data logger is as below.
Manufacturer:
Name: Seiko Instruments Inc.
Address: 8, Nakase 1-chome, Mihama-ku, Chiba-shi, Chiba 261-8507, Japan
2. Warning
This is a Class A product according to the EMC directive. In a domestic environment, this product may
cause radio interference or may be affected by radio interference to the extent that proper measurement
cannot be performed.
3. Notes on Radio Law
When using the GL860 midi LOGGER in the wireless LAN unit (optional), please note the following:
(1) Do not remove the technical standards compliance label. Do not use the device if it does not have a label on it.
(2) This GL860 uses the 2.4GHz frequency band.
The following devices and transmitters use the same frequencies and should not be used near this GL860:
• Microwave ovens
• Pacemakers and other industrial, science, and medical devices
• Radio transmitters used in mobile body identification devices on factory production lines, etc. (transmitters
requiring licensing)
• Interference with radio waves from specified low-power radio stations (radio transmitters not requiring
licensing), Bluetooth, etc. may slow down the communication speed or prevent communication.
(3) The signal may be weak or communications may become slower or impossible depending on the
circumstances in which GL860 is used. Take particular note of steel-reinforced, metal, concrete, and other
structural materials that can inhibit radio waves.
Introduction
I
Introduction