Advertisement
•
When the ring capturing function is set to On, the backup function is not available.
•
The memory that is the same as the capture destination cannot set as the backup save folder.
•
It takes a time for writing after recoding was stopped when many channels are recoding, when interval sampling is fast,
when backup interval is long, because the backup data size becomes large.
•
Sometimes the backup will be failed when the backup data is saved to the FTP server via the wireless LAN by condition
of Wifi communication.
•
CSV format backups can be used with sampling slower than 100ms.
It cannot be used at 5ms,10ms, 20ms, or 50ms.
•
When the backup is performing for the CSV Format, the SD Memory Card exchange and the relay recording are not able
to perform.
•
When the external sampling function is On the backup function is not able to perform.
•
When the memory loop function is set to On, you cannot specify FTP as the backup destination.
If the backup fails during capturing, the "backup failure" is displayed as a status message. In that case, the status message
will be cleared by executing the error clear.
2-7. Data corruption check function
The data corruption check function is a simple check method for checking file integrity.
If the contents of the file have been changed by a third party, etc., a data corruption check shows that the checksum
does not match, indicating that the file has been tampered with.
The data corruption check function adds a checksum to the captured file.
Setting
Off
On
* Checksums are also attached to backup files, ring/relay files, and data-saved files.
For the data corruption check function, refer to "11. Data replaying menu" in "3.4 Setting Menus".
CAUTION
•
Only files with the file format GBD are valid. Checksum is not added to CSV format files.
•
If the captured file is converted with a device other than the GL28-APS, or GL-Connection and saved, the checksum does
not match.
Checksum is not added to the captured file.
Checksum is added to the captured file.
3-49
Chapter 3 Settings and Measurement
Description
Advertisement
Need help?
Do you have a question about the miid LOGGER GL860 and is the answer not in the manual?
Questions and answers
We just purchased a GL860 logger with expansion modules. The connections on the expansion modules are push button style. We are using 24 ga. thermocouple wire and the wires pull out of the connections very easily. Is there a minimum gage that we are to use.