GRAPHTEC miid LOGGER GL860 User Manual page 130

5.9. Network settings
Make network settings for each server and client.
New Line Code
Specifies the line feed code.
Selection item
CR+LF
LF
CR
I/F command function
Set the I/F command function.
<I/F command function>
Selection item
I/F command settings I/F Command
Function
Port number
Keep Alive
CAUTION
When set the I/F command function to Off, you are not be able to connect to our APS (GL28_APS, GL-Connection) via
TCP/IP (Wireless LAN). Connection via USB is possible.
Starts a new line with CR+LF code.
Starts a new line with LF code.
Starts a new line with CR code.
Off, On
Enable/disable the I/F command server function via the network.
The I/F command function via TCP/IP affects the UDP/IP server function.
The I/F command function via USB can be used regardless of this setting.
1024 to 65535
Set the port number used by the IF command function.
Off, 10 seconds, 30 seconds, 1 minute, 10 minutes, 30 minutes, 1 hour
Set the timeout time to disconnect the socket connection when no communication.
(Valid only for IF command function.)
3-74
Chapter 3 Settings and Measurement
Description
Description