Connections; Power; Computer - Intermec EasyCoder PF2i User Manual

Connections

Power

Computer

EasyCoder PF2i Bar Code Label Printer User's Guide (Fingerprint Version)
To connect power to the printer:
1 Place the printer on a level surface, near an AC outlet. You
should be able to easily access the printer to load media and to
remove the printout.
2 Check that the printer is switched off.
3 Connect the power cord from the socket on the rear plate to
an electrical outlet (90 to 265 VAC).
The EasyCoder PF2i printer is fitted with one 9-pin D-style
subminiature (DB9) socket for the RS-232 serial interface port
(see "Interfaces" on page
RS-232 Serial Interface ("uart1:")
Use the serial interface with Intermec LabelShop or the Intermec
InterDriver. Also use it with the Intermec Direct Protocol or the
Intermec Fingerprint programming language because you can
receive error messages from your printer. Before you can use the
serial interface, you may need to set up the communication
parameters, such as baud rate, parity, etc. as described in
Up the Printer" on page
USB Interface ("usb1:")
Use the USB interface with an USB-compatible version of the
Intermec InterDriver for printing. The USB interface is not
suitable for programming because the host cannot receive error
messages from your printer.
Optional Interface and Network Boards ("uart2:", "uart2:",
"centronics:", or "net1:")
Several types are available (see
"Setting Up the Printer" on page
and "Interfaces" on page 143
instructions.
Chapter 2 — Installation
143).
49.
"Options" on page
49, "Setup Mode" on page
for connection and setup
"Setting
89). Refer to
67,
13