Description - Intermec EasyCoder PF2i User Manual

Chapter 6 — Setting Up the Printer

Description

50 EasyCoder PF2i Bar Code Label Printer User's Guide (Fingerprint Version)
The setup controls the printer in regard of serial communication,
test and service operations, and specifies which type of media and
(optionally) ribbon is loaded in the printer.
Check the list of the printer's default setup parameters on the
next page to see if they match your requirements. If not, you will
have to change the setup using one of the methods described
below. The setup may also be changed by Intermec PrintSet,
InterDriver, and LabelShop, or third-part application programs.
Setup Mode
• Press the Setup key on the printer's built-in keyboard to enter
the Setup Mode.
• Select the Setup option in Intermec Shell to enter the Setup
Mode.
• Execute the Intermec Fingerprint SETUP instruction to enter
the Setup Mode.
• Access the Setup Mode via the printer's home (requires an
optional EasyLAN interface board).
See "Setup Mode" on page 67
documentation.
Intermec Fingerprint
• Use setup strings to change individual setup parameters
remotely from the host.
• Use setup files to create sets of setup parameters remotely
from the host.
See the Intermec Fingerprint manuals.
Intermec Direct Protocol
• Use setup strings to change individual setup parameters
remotely from the host.
See the Intermec Direct Protocol v8.xx Programmer's Reference
Manual (P/N 1-960597-xx).
and the EasyLAN